I purchased this receiver and was assured that it was the same as the existing 7058YN-03 receiver. First off, I discovered when it arrived that the 9-pin connector did not match the AMP 9-pin on the existing receiver, so I had to order and wait to receive a AMP to MOLEX adapter connector that I could find nowhere else.
Next, when I replaced the receiver and re-powered it, the receiver would not respond to the remote unless I held the remote within about 2 ft. of the fan. The fan is mounted on a sloped ceiling and is 10 ft. above the floor!
The reason I bought the receiver in the first place was that I guessed that the cyclic hum from the fan was due to a bad capacitor on the circuit board but the hum was the same with the replacement.
I put the old receiver back in the fan and am now stuck with over $60 worth of unusable stuff.
I'd give it one star but I feel at least partly responsible for an incorrect diagnosis. The hum is likely from the motor windings so next step will be to replace the fan itself.